Changelog of DMMC-STAMP-BREAKOUT MMC

V2.06

• Update CPLD to v1.12
• Update libdmmc to v2.16
• Fix default FRU

V2.05

• RTM_Vadj: set both DAC channels

V2.04

• Fix RTM_Vadj for AD5338 based RTMs

V2.03

• Add BoB Rev.C support
• Fix RTM_Vadj value 1800mV
• Update CPLD
• Update libdmmc

V2.02

• Add FPGAn_UART selector
• Add reg.dump, stack dump & backtrace on watchdog reset

V2.01

• Make MCH show_fru show product name from FRU
• Fix manual fru_start/shutdown from MCH

V2.00

• Migrate to new CPLD regmap

V0.14

• Fix RTM Isens offset calibration

V0.13

• Update to libdmmc v1.14

V0.12

• Update CPLD before waiting for power good

V0.11

• Fix MCH warnings / fail LED / power cycle in bootloader mode

V0.10

• Fix "red LED on payload"

V0.09

• Add detection for STAMP Rev.D & E
• Print STAMP revision as part of version information
• Add RTM fault logging on console
• Make sure RTM PG polarity change is taken over immediately

V0.08

• Fix redundant decimal places on NAT sensor display
• Fix rounding errors in sensors coefficients
• Fix I_RTM sensors increments
• Force I_RTM readings to zero if RTM off
• Don't allow negative values for PMBUS current
• Update FRU product_name

V0.07

• Add support for handle out of crate

V0.06

• Fix eeprom save on "sg reset" cmd

V0.05

• Remove obsolete GPIO test code

V0.04

• Add set fuses command

V0.03

• Add cmd line support for CPLD GPIOs

V0.02

• Update libdmmc
• Add PMBUS configuration

V0.01

• Add support for updating the bootloader

V0.00

• initial