Changelog of DAMC-MOTCTRL MMC

V2.03

• Update CPLD to an even version number

V2.02

• Add mmcmailbox support towards MPSoC PS

V2.01

• Improve PMBUS programming

V2.0

• Migrate to libdmmc v2.0
• Add support for mmcterm
• Add CLI for K7 UART mux
• Add PMBUS voltage monitoring
• Add PMBUS config for TPSxxx chips

V1.21

• Add support for FMC sensors
• Improve IPMI latency
• Fix CPLD error on reset
• Misc RTM fixes and improvements
• Add support for FRU FmcI2cDeviceDefinition
• Support RTM handle in out-of-crate mode
• Add RTM Isens calibration

V1.20

• Fix CPLD error (0xff) on reset

V1.19

• Skip Z3_DRV_EN when 12V not enabled

V1.18

• Make show_fru on MCH show the actual name of the RTM
• Improve IPMB debug logging

V1.17

• Fix detection of unprogrammed power manager
• Include Stamp UID in version info & boot msg

V1.16

• Fix FRU ID in RTM device locator

V1.15

• Add support for MDI variant w/o Z3 PLL
• Avoid PCA9574 errors when booting w/ 12V enabled
• Wait for AMC powerdown seq finished before retrying
• Don't probe FMC EEPROM if FMC module not present
• Add eefd - set EEPROM to factory defaults

V1.14

• FMC: Add support for 32k EEPROM at different address
• FMC: Add support for optional GA-swapped fallback EEPROM addresses
• CPLD: Fix errors when rebooting w/ 12V enabled

V1.13

• Update CPLD to 7.2; fixes swapped interlock lines
• Fix wdg bootloop in case of blocked FMC I2C bus
• Fix wdg reset when i2cd operates on blocked bus
• Restrict RTM UID and DAC access to DESY RTMs
• Add ppf command (set payload power fail policy)
• Fix FRU parser for longer part_no strings
• Fix FPGA INIT & DONE readout
• Detect unprogrammed power manager

V1.12

• Add support for FMC sensors
• Fix CPLD auto-update on unprogrammed boards
• Add support for SPI flash update
• Add i2cget/set commands

V1.11

• Add DRTM-PZT4 compatibility mode
• Fix assignment of DC/DC temperature sensors

V1.10

• Fix MCH warnings / fail LED / power cycle in bootloader mode

V1.09

• Update CPLD (fix "stuck at boot")

V1.08

• Fix redundant decimal places on NAT sensor display

V1.07

• Fix rounding errors in sensors coefficients
• Fix I_RTM sensors increments
• Force I_RTM readings to zero if RTM off

V1.06

• Add R/W support for FMC EEPROMs
• Add FMC EEPROM addr. width auto-detection
• Fix PLL startup delay issue
• Add support for out-of-crate mode

V1.05

• Fix "Z3 compatibility" FRU parsing
• Fix channel name VCC_1V8 -> VCC_1V8A
• Fix SI5340 console message

V1.04

• Fix watchdog reset loop in case of unprogrammed powermanager

V1.03

• FRU write verify, fix corrupt AMC FRU

V1.02

• Wait for shutdown complete, when handle is pulled. Keep 12V PP, until PSM has gracefully shut down.

V1.01

• PSM orderly shutdown on pmc write|verify command

V1.00

• Change Jenkins build to use recent CPLD interface (with EFB)

V0.18

• Last version using "legacy CPLD" as default build (-DCPLD_NO_EFB=1)
• Support in-application update of CPLD
• Support IMON channels for current monitoring
• Support PMBUS configuration from MMC
• Use PMBUS commands instead of GPIO to switch payload pwr

V0.17

• preliminary version w/ FMC & RTM e-keying

V0.16

• Implement FMC Vadj & ZUP Vcore setting

V0.15

• Add support for updating the bootloader

V0.14

• Intermediate version

V0.13

• Initial version w/ libdmmc